Table of Contents
Advertisement
1. Enter the first character of the password using the keypad or ADJUST control (see PAR.
3.2.4.2 for entry of alphanumeric characters). (To change the password, refer to PAR.
3.2.4.3.)
T
2. Press
word.
3. Repeat steps 1 and 2 until the correct password is displayed, then press
protected setting or menu will now be accessible
!
NOTE: If
the bottom of the screen. Press CLEAR and proceed to step 1 above.
FIGURE 3-5.
3.2.5
OPERATOR CONVENIENCE FUNCTIONS (DISPLAY MENU)
From the power-up screen (Figure 3-3), pressing
menu (see Table 3-3). The functions listed can be modified using the techniques described in
PAR.3.2.4). This function is always available, whether in Local, Remote or Local/Lockout mode.
$
NOTE: If
(see PAR. 3.2.5.1 to 3.2.5.4) can not be saved for power-up. To save for power-up it is
first necessary to change SAVE DISPLAY CHG at the password setup from DISABLE
(default) to ENABLE (see PAR. 3.2.4.3 and Figure 3-5). After saving the changes for
power-up, SAVE DISPLAY CHG at the password setup can be set to DISABLE to pre-
vent future changes if desired.
3.2.5.1
ADJUSTING LCD BRIGHTNESS, CONTRAST AND BACKGROUND
From the power-up screen, (Figure 3-3), press
contrast gradually alternates between light and dark. When the contrast is acceptable, press
to apply the change and exit contrast adjust. Use the
trast. Contrast can also be adjusted from the power-up screen by pressing
T
R
ing
and
BOP HIPWR 080709
to move to the next character and repeat step 1 for the next character of the pass-
the password is incorrect, the message Password incorrect is displayed at
PASSWORD PROTECTION MENU, FACTORY DEFAULTS
is not available when the operator convenience menu is open, these functions
as needed for fine adjustment.
#
opens the operator convenience functions
#
twice to initiate contrast adjustment. The
T
R
and
keys for fine adjustment of con-
!
to verify. The
#
#
once, then press-
3-9
Advertisement
Table of Contents
