Compact 2S Module; Compact Ts Module; Technical Advice (Power Outage) - Auerswald COMpact 4410 USB Installation And Configuration Manual

10
Technical Data
Analog Subscriber Connection
Usage COMpact 2206 USB: 8 connections for analog devices
COMpact 4410 USB: 8 connections for analog devices
Connector Type detachable screw clamp connectors (for three subscrib-
ers also TAE-jacks
Dialling method pulse dial or DTMF
Voltage unloaded max. 40 VDC
Loop current app. 21 mA
Range 2 x 50 , app. 800 m at 0,6 mm
Ringer Voltage app. 45 V
Dial Tones 425 Hz
Impedance analog symmetric
Germany, Switzerland, Luxembourg, Denmark: Z
Austria and Spain: 600
Charge meter pulse switchable, 12 kHz/16 kHz
Internal S Port
0
Usage 1 S port internal
0
Connector Type 4-pole detachable screw clamp connectors, additionally
western modular jacks
Connection Type, internal S basic rate connection as Point-to-Multipoint connec-
0
tion, EURO-ISDN (DSS-1)
Devices, internal 8 ISDN devices maximum, 4 line powered devices maxi-
mum e.g. different ISDN telephones (2 telephones is rec-
ommended)
Range, internal 150 m maximum (for bus wiring, please observe the euro-
pean standards ENV 41001 [DINV 41001] and
EN 28877)
Termination Resistors switchable; default factory settings: on
System Display Connection
Connector Type detachable screw clamp connector (and TAE-jack)
PC Connection
Serial Interface RS-232-C, V.24, 9600-57600 Baud (8 bit, no parity,
1 stop bit), no handshake
detachable screw clamp 3-pole connector
USB Interface Full Speed, V 1.1
Music Input/Output
Input Level adjustable from -18 to +10 dB (1 V
Output Level max. 1 V
Impedance 1 k
Other Data
Casing ABS, Cabinet with cover
Size (W x H x D) 301 mm x 243 mm x 86,5 mm
Weight app. 1500 g
Safety EN 60950, CE
1. Outside of Germany Western modular jacks (Layout
1
)
, switchable 25 Hz/50 Hz
eff
5%, Interval 10%
)
eff
eff
on page 25)
COMpact 2S
Connection Options
Usage
Connector Type
Connection Type, external
Connection Type, internal
Devices, internal
R
Range, internal
Termination Resistors
Other Data
Installation
Power Supply
Size
Weight
Safety

COMpact TS Module

Connection Options
Usage
Connector Type
Interface Door Terminal
Power Supply Door Terminal 12 VDC, 100 mA
Relay Contact
Door Key Input Voltage
Alarm input voltage
Active condition Alarm input Contact closed for more than 0,5 sec
Other
Installation
Power Supply
Size
Weight
Safety
Technical changes may be introduced without prior notice

Technical Advice (Power Outage)

If you like to use the PBX during a power outage, you will need an unin-
terruptable power supply, e.g. the USV-500 Sinus (Auerswald acces-
sory).
You can switch a single emergency mode telephone like the system tel-
ephone COMfort 1000 (Auerswald accessory) during a power outage
from the internal to the external S
swald accessory).
Module
0
1 S port internal, 1 S port switchable as internal or
0 0
external S port (jumper)
0
4-pole detachable screw clamp connectors, additionally
western modular jacks
S basic rate connection as Point-to-Multipoint or Point-
0
to-Point connection, Euro-ISDN (DSS-1), PBX is self
powered
S basic rate connection as Point-to-Multipoint connec-
0
tion, EURO-ISDN (DSS-1)
8 ISDN devices maximum, 4 line powered devices maxi-
mum e.g. different ISDN telephones
(2 telephones recommended)
150 m maximum (for bus wiring, please observe the euro-
pean standards ENV 41001 [DINV 41001] and
EN 28877)
switchable; default factory setting: on
Slot insert in the case of the COMpact 4410 USB
from COMpact 4410 USB
92 x 60 x 17 mm
ca. 49 g
EN 60950, CE
3 Relay outputs, default factory settings: for the door ter-
minals,
2 door key inputs reconfigurable to alarm inputs
detachable screw clamp connectors
FTZ-123-D12-0
floating, 30 V/1 A maximum
configuration dependent 0 V or
5-15 VAC/DC with door key (make contact)
Depending on configuration 0 V or 5-15 VAC/DC
via alarm contact (make contact)
Slot in the cabinet of COMpact 4410 USB or
COMpact 2206 USB
from COMpact 4410 USB or COMpact 2206 USB
92 x 60 x 14 mm
ca. 47 g
EN 60950, CE
port with the ISDN-Autoswitch (Auer-
0