Auerswald COMpact 4410 USB Installation And Configuration Manual page 16

16
Creating a Basic Configuration
Now click on „Exchange line numbers" in the left window pane. The
window content appearing is dependent the kind of connection
(Point-to-point connection,
mixed).
You have to enter the country code and area code into entry fields
at the top of the window.
Point-to-point connection: In case of a Point-to-point connection
(a base number with additional Direct Dial Inward numbers) you
have to enter your base number without area code into the column
„PtP base number" of the first table.
If you have two ISDN exchange lines with the same base number
(COMpact 4410 USB with 2 external S
these separately and activate both check boxes in the column „bun-
dle".
(The reception number, e.g. „0", is not part of the base number, but
is a Direct Dial Inward number.)
The Direct Dial Inward numbers received from the network provider
are entered into the column „MSN/DDI" of the following table.
you have the Direct Dial Inward number block 1-99 and use the 1,
the numbers 10-19 are not available anymore) Assign an S
each number by activating a check box in the column „S
you have a trunk bundle for S
USB both columns are activated simultaneously.)
Example:
05306 / 9200 - 0
area code
Point-to-multipoint connection: In case of one or two Point-to-
multipoint connections you have to enter your MSNs without area
code into the column „MSN/DDI". Assign an S
by activating a check box in the column „S
Now click on „internal telephone numbers" in the left window pane.
You can create internal subscribers in this table by entering the
number and assigning this number to a port (select analog or S
ports in the column „Module", select port number in the column
„Internal port" and kind of device in the corresponding column).
The two-digit numbers 10-59 and the three-digit numbers 100-599
are available. The usage of two-digit numbers reduces the available
amount of three-digit numbers. Example: If the number 11 is
assigned, the numbers 110-119 (Emergency numbers!) are not
available anymore.
The program can also generate a rising list of numbers (enter the
smallest number, step into the name entry field to the right with the
right arrow-key and start the function by clicking the right mouse
key).
The 1st MSN entered into individual Auerswald system tele-
phones, ISDN telephones as well as ISDN PC-controllers
must match with here created internal number (please consult
the chapter Configuration of ISDN Devices on page 18
make sure that this 1st MSN of the corresponding device is also pre-
sented to the PBX.
Point-to-multipoint connection
ports only), please enter
0
0
1, ...". (If
0
ports 1 and 2 on a COMpact 4410
0
base number
DDI number
port to each number
0
1, ...".
0
besides this
PtP connection
or
(If
port to
PtmP connection
0