Auerswald COMpact 4410 USB Installation And Configuration Manual page 17

17
First Installation Steps
Now click on „call distributions ... External -> subscriber" in the left
window pane. You can define the distribution of external calls to
individual internal subscribers in this table (the exchange line num-
bers are listed top to bottom and the internal numbers are listed left
to right). Click on the coloured buttons „immediately" or „delayed"
first and then into the fields to be modified.
If internal numbers and external Direct Dial Inward numbers (DDIs)
are matching, you can create a 1:1 assignment with the „linear call
distribution". If you have received the Direct Dial Inward numbers -
40 to -59 for your PtP-connection and created the same numbers
40 to 59 in the window „internal telephone numbers", you can
assign the corresponding internal number to each external DDI by
clicking on the button „linear call distribution".
You have defined a basic configuration now which enables you to
make and receive calls. This configuration has to be stored into the
PBX. Click on the button „Save" and then on „PBX".
For backup purposes you can save this configuration to disk by
clicking on „Save" and then „File".
If you connect more than one Auerswald device to the selected
interface (e.g. PBX and system telephone to the USB port), select
the direct connection to the PBX here. If this is not available, you are
able to store this configuration via system telephone COMfort 1200
or 2000 into the PBX (Routing; see also page 35).
If you stored the configuration into the PBX and saved it to a file
(option), you may close the configuration (click „File" and „Close")
or leave the PC program (click „File" and „Quit"). In either case, you
will be asked, if you like to discard your settings. Click on „No".