Drive Belt (For Alternator) - Mitsubishi 3000GT 1991 Service Manual

<Vehicles without air conditioner>
GENERAL

6. DRIVE BELT (For Alternator)

(Inspect tension)
(1) Measure the deflection with a force of 100 N (22 Ibs.)
applied to belt mid-point between pulleys shown in the
illustration. If the standard value is not obtained, make
adjustment.
Standard value: 4.0 - 5.5 mm (.157 - 216 in.)
(2) On vehicles without air conditioner, set a tension gauge at a
position marked with r3 in the illustration to measure the
belt tension.
OOFOO07
ENGINE OIL
7.
(Inspect oil level)
indicated on the oil level gauge.
(2) Make sure that engine oil is not very dirty or is free from
coolant or gasoline and has an appropriate viscosity grade.
(Change)
Always use lubricants which conform to the requirements of
the API classification "For Service SG" or "For Service SGKD"
when available, and have the proper SAE grade number for the
expected temperature range.
Never use nondetergent or straight mineral oil.
(2) Remove the drain plug and drain the engine oil.
(3) Tighten the drain plug to 40 Nm (29 ft.lbs.).
(4) Pour new engine oil through the oil filler.
Caution
1. Cover the alternator with waste cloth or the like before
pouring engine oil to make sure that even if oil is spilt,
it may not drop on the alternator.
2. Use an oil mug or a funnel to pour oil.
Engine oil total capacity:
(5) Check to ensure that the engine oil level is within the level
range indicated on the oil dip stick.
TSB Revision
4.0 liters (4.2 qts.)
[excluding oil filter 0.3 liter (l/2 qt.)
and oil cooler 0.21 liter (l/2 qt.)]
MOOSAAH