Mitsubishi 3000GT 1991 Service Manual page 722

REAR SUSPENSION <AWD>
(4) Secure the dust cover with the clip ring.
Clip ring ends
(Could be 180"
opposite end)
SERVICE POINTS OF INSTALLATION
6 . I N S T A L L A T I O N O F S T A B I L I Z E R L I N K / 2. SELF-
cover.
install the dust cover.
At this time, make sure that the clip ring ends are located at
a point 90" f 20" with reference to the link axis.
LOCKING NUT / 1. SELF-LOCKING NUT
(1) Secure the stabilizer link ball stud with a wrench and
mount the self-locking nut.
(2) Hold the stabilizer link with a wrench so that its
protrusion on the lower arm side (dimension A) is up to
specification, then mount the self-locking nut.
Standard value: 5 - 7 mm (.197 - .276 in.)