Mitsubishi 3000GT 1991 Service Manual page 858

Connector
6
Suction connector
mounting portion
of oil pump body
STEERING
INSPECTION
Check the flow control spring for wear.
l
Check the shaft of the pulley for play and round movement.
l
Check the groove of rotor vane for "stepped" wear.
l
Check the contact surface of cam ring and vanes for
l
"stepped" wear.
Check the vanes for breakage.
l
CHECK OF GAP BETWEEN VANE AND ROTOR GROOVE
Install vane to rotor groove as illustrated. Measure the gap
between vane and rotor groove with thickness gauge.
Limit: 0.06 mm (.0024 in.)
SERVICE POINTS OF REASSEMBLY
25. 21. 13. 9. 7. INSTALLATION OF O-RINGS
Apply specified fluid on O-rings to install.
No.
1
2
3
4
5
6
14. INSTALLATION OF SPRING
Fit the spring to the oil pump body with the larger-diameter
end at the terminal assembly side.
TSB Revision
I.D. x Width
1 1 x 1 . 9 (.433 x ,075)
13x1.9
17.8 x 2.4 (.701 x ,094)
13.5x1.5
3.8 x 1.9 (. 150 x ,075)
16.8 x 2.4 i.661 x ,094)
mm (in.)