Mitsubishi 3000GT 1991 Service Manual page 709

REAR SUSPENSION <AWD> - Service Adjustment Procedures
Trailing arm (L.H.)
TSB Revision
REAR WHEEL ALIGNMENT INSPECTION
CAMBER
Standard value: -0"lO' + 30'
To adjust camber, turn the lower arm mounting bolt on the
crossmember side.
NOTE
Left wheel: Clockwise (0 camber)
Right wheel: Clockwise (0 camber)
The difference between the right and left wheels shoiuld be 30'
or less.
One graduation changes camber by about 12'.
TOE-IN
Standard value: 0.5 -t 2.5 mm (.Ol + .09 in.)
To adjust toe, turn the trailing arm mounting bolts on the
crossmember side on both sides the same amount.
NOTE
Left wheel: Clockwise (toe-in)
Right wheel: Clockwise (toe-out)
The difference between right and left wheels should be 3 mm
One graduation changes toe by about 2 mm (.08 in.).
Caution
1. Adjust the eccentric cam bolt within 90" from' the
central position.
2. Adjust camber and toe, in that order,
adjusted, be sure to adjust toe also.
3. For the vehicles with 4WS, make the adjustments with
the 4WS tie rod end disconnected from the trailing arm.
and,
if camber is