Mitsubishi 3000GT 1991 Service Manual page 898

42-26
WINDSHIELD AND LIFTGATE GLASS INSTALLATION PROCEDURE
Body side
Cleaning bonding surface
Scoop out existing adhesive to less than
2 mm (.08 in) thick and clean bonding
surface. Then dry 3 minutes or more.
Applying primer
Apply primer amply on bonding surface
and dry 3 minutes or more.
Fit the liftgate mouldrng upper and
BODY
Removal of moutding
(wire)
Cleaning bonding surface
Scoop out existing adhesive com-
Apply the window dam to the glass along the reference position inside of the
Water test
(after about 30 minutes _............__,,,__........,........,.....,,,..,
Installation of
moulding.
painted surface
TSB Revision
Cleaning bonding surface
Clean the bonding surface and dry
3 minutes or more.
I
If water leaks
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ~