Mitsubishi 3000GT 1991 Service Manual page 380

CLUTCH
SERVICE POINTS OF INSTALLATION
5. APPLICATION OF GREASE TO RELEASE FORK
(1) Apply a coating of the specified grease to the point of
(2) Apply a coating of the specified grease to the end of the
4. APPLICATION OF GREASE TO CLUTCH RELEASE BEAR-
ING (FWD)
Pack the inner surface of the clutch release bearing and the
groove with the specified grease.
Specified grease: MITSUBISHI genuine grease
grease
2. APPLICATION OF GREASE TO CLUTCH DISC / 1.
CLUTCH COVER ASSEMBLY
Clutch disc
(2) Using the universal clutch disc aligner, position the
(3) Install the clutch cover assembly. Tighten the bolts a
Clutch cover
assembly
TSB Revision
contact with the fulcrum and the point of contact with
the release bearing.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
Caution
When installing the clutch, apply grease to each
part, but be careful not to apply excessive grease;
excessive grease will cause clutch slippage and
shudder.
release cylinder's push rod and to the push rod hole in
the release fork.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
Part No. 0101011 or equivalent
disc spline, and then use a brush to rub it in.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
clutch disc to the flywheel.
little at a time, working in a diagonal sequence, finally
tightening them to the specified torque.