Mitsubishi 3000GT 1991 Service Manual page 427

MANUAL TRANSAXLE <FWD>
1
Socket
wrench
Oil seal
SERVICE POINTS OF DISASSEMBLY
6. REMOVAL OF LOCK PIN
Drive out the lock pin from the control finger using the pin
punch.
Caution
When removing the lock pin, turn the control lever to
such position that the lock pin will not contact the
clutch housing.
7. REMOVAL OF SPRING PIN
Drive out the spring pin from the stopper body using the pin
punch.
Caution
When removing the spring pin, pull the control shaft in
the direction illustrated so that the spring pin will not
contact the clutch housing.
SERVICE POINTS OF REASSEMBLY
17.16. INSTALLATION OF NEEDLE BEARINGS
Install the needle bearing flush with the surface A of the
clutch housing.
15. INSTALLATION OF OIL SEAL
Install the control shaft oil seal using a socket wrench.
7. INSTALLATION OF SPRING PIN / 6. LOCK PIN
Caution
Do not reuse the spring pin and lock pin.
control shaft center.
TSB Revision