Mitsubishi 3000GT 1991 Service Manual page 337

INTAKE AND EXHAUST - Exhaust Manifold <Non Turbo>
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Removal and Installation of Front Exhaust Pipe
l
Removal and Installation of Condenser Fan Motor
l
Assembly <Vehicles with Air Conditioner>
(Refer to GROUP 14 - Radiator.)
45 Nm
33 ft.lbs.
24Nm
2
45 Nm
33 ft.lbs.
Removal steps of exhaust manifold (front)
1. Drive belt (Alternator)
(Refer to GROUP 11 -
Service Adjustment procedures)
2. Alternator assembly
3. Oil level gauge guide
4. Heat protector
5. Exhaust manifold (front)
6. Gasket
9 - 11 ft.lbs.
Removal steps of exhaust manifold (rear)
INSPECTION
Check the following points; replace the part if a problem is
found.
Check for damage of cracking of any part.
l
TSB Revision
33 ftlbs.
7
7. Stud
8. Heat protector
9. EGR pipe <Vehicles for California>
11. Gasket
60 Nm