Mitsubishi 3000GT 1991 Service Manual page 82

r
ENGINE
INSPECTION
CAMSHAFT
Measure cam height (longer diameter of the cam). If it exceeds
the limit, replace the camshaft.
Standard value:
Intake side
Exhaust side
Limit:
Intake side
Exhaust side
SERVICE POINTS OF INSTALLATION
11. INSTALLATION OF LASH ADJUSTER
(2) Using a small wire, move the plunger up and down 4 or
5 times while pushing down lightly in the check ball in
order to bleed out the air.
(3) Install the lash adjuster to the cylinder head.
9. INSTALLATION OF CAMSHAFT
dead center.
(2) Check that the rocker arm is installed correctly on the
lash adjuster and valve.
(3) Install the camshaft noting the identification mark
(stamped on the hexagon sectioned).
Identification mark: Intake side
(4) Install the camshafts with their dowel pins positioned
as shown in the illustration.
8. 7. 6. 4. 2. INSTALLATION OF BEARING CAPS
and 4 bearing caps bear the front mark. Install these
caps with the mark lined up with the front mark on the
cylinder head.
Identification mark: Intake side
TSB
Revision
Exhaust side C
Rear side ,
Exhaust side E
35.49 mm (1.3972 in.)
mm (1.3858 in.)
35.20
34.99 mm (1.3776 in.)
mm (1.3661 in.)
34.70
V
I