Mitsubishi 3000GT 1991 Service Manual page 288

CRUISE CONTROL SYSTEM
TSB Revision
CRUISE CONTROL SWITCH INSPECTION
(1) Remove the air bag module using the following procedure.
for more than 30 seconds.
Caution
The capacitor in the SRS diagnosis unit retains
enough voltage to deploy the air bag for a given
period even after disconnection of the battery. If an
operation is performed during that given period,
unintended deployment of the air bag could result
and cause serious injury.
connector (squib connector) from the air bag module,
force the lock outward and pry it with a plain screwdriv-
er as shown at left so that no undue force will be
exerted on the connector when it is removed.
clean, dry, flat place with the pad side up.
(2) Disconnect the connector of the control switch and operate
the control switch to measure the resistance between the
individual terminals.
If the readings are as shown below, the control switch may
be considered good.
Switch operation
When switch is not operated
When switch is operated toward you
(CANCEL switch: ON)
When switch is operated upward
(RESUME switch: ON)
When switch is operated downward
(SET switch: ON)
Resistance between
terminals
No continuity
Approx. 0 1R
Approx. 820 1R
Approx. 2,700 fi