Mitsubishi 3000GT 1991 Service Manual page 887

14.5 mm (.57 in.)
Stabilizer
inner rear
8. Adjust glass to have standard clearance between the weatherstrip holder and window glass.
Caution
Measure the clearance, specified in section A-A, B-B and C-C, at the corresponding weatherstrip
holder screws as shown in the illustration.
of the glass guide rear
track same amount.
Move the stabilizer Inner front and
Adjust-
ment of up stop up and down to adjust
forward the forward or rearward tilt of
or back- glass when glass is fully closed.
2 ward tilt
of glass Caution
Do not turn the stabilizer
inner front adjusting bolt.
BODY
5. Remove the stabilizer inner front and adjust the adjusting
bolt for the dimension shown here.
5 mm (20 in.)
6. Adjust the adjusting bolt for the stabilizer inner rear
dimension shown here.
7. Raise door window glass. Push glass against the outer
stabilizer of the door belt line outer weatherstrip and insert
cloth or the like between the door inner panel and glass.
Adjustment procedures
Stabilizer
inner front1
Revision
TSB
7.7
7.0
P
42-15
12.0