Mitsubishi 3000GT 1991 Service Manual page 622

27-26
REAR AXLE <AWD>
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF DIFFERENTIAL CARRIER
Install the rear wheel oil pump by inserting it through the
mounting hole and install the differential carrier securely. \yi
Caution
Use care not to damage the rear wheel oil pump gears.
3. CONNECTION OF PROPELLER SHAFT
Align the mating marks on the flange yoke and the
companion flange to install the propeller shaft.
INSPECTION BEFORE DISASSEMBLY
Hold the working base in a vice, and attach the differential
carrier to the working base.
FINAL DRIVE GEAR BACKLASH
With the drive pinion locked in place, measure the final drive
gear backlash with a dial indicator on the drive gear.
NOTE
Measure at four points or more on the circumference of the
drive gear.
Standard value: 0.11 - 0.16 mm (.004 - .006 in.)
DRIVE GEAR RUNOUT
Measure
side of the drive gear.
Limit: 0.05 mm (.002 in.)
FINAL DRIVE GEAR TOOTH CONTACT
Check the final drive gear tooth contact by following the steps
below.
of the drive gear teeth.
TSB Revision
the drive gear runout at the shoulder on the reverse