Mitsubishi 3000GT 1991 Service Manual page 573

Puller
[commercially
Companion flange
Self
nut
PROPELLER SHAFT
15. REMOVAL OF CENTER BEARING ASSEMBLY
First remove the center bearing bracket and then remove
available)
the center bearing using a puller (commercially available).
INSPECTION
Check the propeller shaft splines for wear or damage.
l
Check the ball grooves in inner or outer race for uneven
l
wear, damage or rust.
Check ball surface for rust, wear or other damage.
l
Check the cage for rust or damage.
l
SERVICE POINTS OF REASSEMBLY
Rubber mount
15. INSTALLATION OF CENTER BEARING ASSEMBLY / 14.
COMPANION FLANGE / 13. SELF-LOCKING NUT
center bearing bracket.
(2) Install the center bearing assembly to the rear propeller
shaft with its dust seal facing the companion flange
side.
(3) Install, lining up the mating marks on the companion
flange and the rear propeller shaft.
(4) While tightening the self-locking nut, install the center
bearing assembly with the companion flange.
e
10. INSTALLATION OF LOBRO JOINT BOOT
Tape the serration of the center propeller shaft and then
install the Lobro joint boot.
8. INSTALLATION OF LOBRO JOINT ASSEMBLY
Assemble the Lobro joint as follows:
grooves of the inner and outer races.
Specified grease: Repair kit giease
10X0018
TSB Revision
25-9