Mitsubishi 3000GT 1991 Service Manual page 713

REAR SUSPENSION <AWD>
REMOVAL AND INSTALLATION
Upper arm removal steps
2. Upper arm mounting nut
3. Upper arm mounting.bolt
4. Upper arm
Lower arm removal steps
5. Lower arm mounting nut
6. Lower arm mounting bolt
Stabilizer link to lower arm
Self-locking nut
9. Lower arm
NOTE
For tightening points marked with *, first temporarily tighten
and then ground the vehicle to torque to specification where the
vehicle is empty.
Post-installation Operation
Dust
cover
SERVICE POINTS OF REMOVAL
1. REMOVAL OF SELF-LOCKING NUT
Using the special tool, disconnect the upper arm ball
from the knuckle.
NOTE
(1) Do not remove the nut from the ball joint, but just
loosen it.
(2) Suspend the special tool with a rope to prevent it from
dropping.
8. REMOVAL OF SELF-LOCKING NUT
Lower down the lower arm on the crossmember side.
Then, install the special tool and disconnect the lower arm
ball joint from the knuckle.
NOTE
loosen it.
(2) Suspend the special tool with a rope to prevent it from
dropping.
TSB
Revision
joint