Mitsubishi 3000GT 1991 Service Manual page 619

B.J. boot band: 20 - 74 #BJ95
REAR AXLE <AWD> - Drive Shaft
(3) Fill the inside of the B.J. and B.J. boot with the specified
grease.
Specified grease: Repair kit grease
Caution
The grease in the repair kit should be divided in half
for use, respectively, at the joint and inside the
boot.
A special type of grease is used on the joint. Be
cautious to ensure that not other grease is allowed
to come in contact with the joint.
1 (4) Secure the boot bands.
Lever
Caution
1. The boot bands should be tightened with the
2. The B.J. boot band and T.J. boot band are
5. INSTALLATION OF SPIDER ASSEMBLY
Apply the specified grease furnished in the repair kit to
(1)
the spider assembly.
Specified grease: Repair kit grease
(2) Install the spider assembly with the chamfered spline
end first.
llE560
2. 1. INSTALLATION OF T.J. BOOT BANDS
Set the T.J. boot bands at the specified distance in order to
adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot band securely.
Standard value: 85 + 3 mm (3.35 + .I2 in.)
TSB Revision
drive shaft at a 0" joint angle.
identified by the identification number stamped
on the lever. Install correct ones at correct
positions.
27-23
125 g (4.4102.)