Mitsubishi 3000GT 1991 Service Manual page 406

22-26
MANUAL TRANSAXLE .<FWD>
Amount
27. INSTALLATION OF OIL GUIDE
Install the oil guide to the transaxle case as illustrated.
26. INSTALLATION OF TRANSAXLE CASE
(1) Place the selected spacers on the intermediate gear
and differential's bearing outer race. Also insert the
selected spacer between the output shaft bearing outer
race and the transaxle case.
(2) Set so that the threaded hole of the reverse idler gear
shaft's head is facing in the direction indicated in the
illustration.
NOTE
If there is a great deviation in the direction in which the
threaded hole is facing, it will be impossible to align the
threaded hole and the hole in the case after the
l-2 mm
transaxle case is installed.
(3) Apply specified sealant to the clutch housing side of the
transaxle case.
Specified' sealant: MITSUBISHI genuine
Caution
Squeeze out sealant from the tube uniformly with-
out excess or discontinuity.
(4) Install the transaxle case onto the clutch housing.
(5) Insert a Phillips screwdriver [8 mm (.32 in.) shaft
diameter] into the bolt hole in the case, as shown in the
figure, and use it to align the threaded hole of the
reverse idler gear shaft with the bolt hole in the
transaxle case.
(6) Install the reverse idler gear shaft bolt and tighten the
bolt by fingers.
(7) Tighten the all transaxle tightening bolts to specified
torque.
(8) Tighten the reverse idler gear shaft bolt to specified
torque.
16.15. INSTALLATION OF LOCK NUTS
(1) Install the special tool to the splined end of input shaft.
(2) Screw a bolt [lo mm (.40 in.)] into the hole on the
periphery of clutch housing and attach a spinner handle
to the special tool.
TSB Revision
Part No. MD997740 or equiva-
lent