Mitsubishi 3000GT 1991 Service Manual page 974

51-36
Inspection of stop position
EXTERIOR
SERVICE POINT OF REMOVAL
8. REMOVAL OF LIFTGATE MOULDING, UPPER
Using a special tool, pry the clip portion to remove the
upper liftgate moulding.
INSPECTION
WIPER MOTOR
Check the wiper motor with it mounted on the vehicle and with
its harness connector disconnected.
Operation of Wiper Motor
Connect a battery to the wiper motor, as shown, to check the
operation of the wiper motor.
Wiper Motor Stop Position
and intermediately disconnect the battery to let the wiper
motor stop.
motor stops at the automatically-stopped position after
operation.
WIPER WASHER SWITCH
terminals.
NOTE
Revision
TSB
that there is continuity between the terminals.