Mitsubishi 3000GT 1991 Service Manual page 69

ENGINE - Enaine Assemblv
SERVICE POINTS OF REMOVAL
15. DISCONNECTION OF Ail? CONDITIONER COMPRES-
SOR / 16. POWER STEERING OIL PUMP
Disconnect air conditioner compressor and power steering
oil pump (with the hose).
NOTE
The removed air conditioner compressor and power steer-
ing oil pump should be fastened (by using rope, etc.) in .a
position that will not interfere with the removal/installation
of the engine assembly.
34. REMOVAL OF ENGINE MOUNT BRACKET
Before removing the engine mount bracket installation bolt,
use a chain block or similar arrangement to suspend the
engine assembly (to the extent that there is no looseness of
the chain).
37. REMOVAL OF ENGINE ASSEMBLY
After checking that the cables, hoses, harness connectors,
etc. are all removed, slowly raise the chain block to lift the
engine assembly upward out of the engine compartment.
SERVICE POINTS OF INSTALLATION
37. INSTALLATION OF ENGINE ASSEMBLY
When mounting the engine, check to be sure that the
cables, hoses, harness connectors, etc. are all in the correct
position.
34. INSTALLATION OF ENGINE MOUNT BRACKET
Attach the engine mounting bracket so that the arrow mark
on the mounting stopper is in the direction as shown in the
illustration.
TSB Revision
Ml 1SDBC