Mitsubishi 3000GT 1991 Service Manual page 647

POWER PLANT MOUNT
ENGINE ROLL STOPPER
REMOVAL AND INSTALLATION
Pre-removal and Post-installation
Operation
Removal and Installation of Condenser
l
Fan Motor Assembly <Turbo>
(Refer to GROUP 55 - Condenser and
Condenser Fan Motor.)
Removal and installation of Catalytic
l
Converter (Left) <Turbo>
(Refer to GROUP 15 -Turbocharger
<Rear>.)
Front stopper bracket removal steps
1. Front roll stopper bracket and
connection bolt
2. Front roll stopper bracket installation bolt
3. Front roll stopper bracket
4. Heat protector <Turbo>
Rear roll stopper bracket removal steps
5. Air hose A <Turbo>
6. Air intake hose C <Turbo>
l
+
7. Rear roll stopper bracket and engine
connection bolt
8. Rear roll stopper bracket installation bolt
9. Rear roll stopper bracket
43 - 51 ftlbs.
engine
SERVICE POINT OF REMOVAL
9. REMOVAL OF REAR ROLL STOPPER BRACKET
(2) Turn the rear roll stopper bracket in the direction shown
in the illustration and lift upward to remove.
INSPECTION
Check each insulator for cracks or damage.
l
Check each bracket for deformation or damage.
l
SERVICE POINTS OF INSTALLATION
9. INSTALLATION OF REAR ROLL STOPPER BRACKET
Install the rear roll stopper bracket as shown in the
illustration.
7. INSTALLATION OF REAR ROLL STOPPER BRACKET
AND ENGINE CONNECTION BOLT
Install the bolt as shown in the illustration.
9
TSB Revision
32-5
45 Nm
36 - 43 ft.lbs.