Mitsubishi 3000GT 1991 Service Manual page 396

MANUAL TRANSAXLE <FWD>
TSB
Revision
9. DISCONNECTION OF TRANSAXLE MOUNT
Raise transaxle assembly with a jack up to a level where
mount bracket no longer receives its weight and remove
transaxle mount insulator bolt.
Caution
Support the transaxle assembly with the jack so that
no localized force is applied to the assembly.
13. DISCONNECTION OF TIE ROD END
Using the special tool, disconnect the tie rod end from the
knuckle.
Caution
1. Be sure to tie the cord of the special tool to the
nearby part.
2. Loosen the nut but do not remove it.
14. DISCONNECTION OF LOWER ARM BALL JOINT
Using the special tool, disconnect the lower arm ball joint
from the knuckle.
Caution
1. Be sure to tie the cord of the special tool to the
nearby part.
2. Loosen the nut but do not remove it.
17. REMOVAL OF DRIVE SHAFT (LEFT SIDE), INNER SHAFT
ASSEMBLY
(1) Remove the bearing bracket mounting bolts and insert
the pry bar between the bearing bracket and the
cylinder block.
from transaxle assembly.
NOTE
Remove drive shaft and inner shaft assembly as an
assembly together with hub, knuckle, and other parts.
shaft assembly with wire or something similar to
prevent it from sharply bending or turning at each joint.