Mitsubishi 3000GT 1991 Service Manual page 650

32-8
POWER PLANT MOUNT -
Front
Rear
Bushing A
Inner sleeve
Press in bushings A and B so that the arrows on their bottom
surfaces may be directed in the crosswise direction (except
those on No. 1 crossmember of FWD vehicles).
Caution
Shifting of the arrow in the direction of rotation shall be
within 1k5" of the crosswise direction.
Press in bushings A and B so that the projecting amount of the
Bushing B
inner sleeve agrees with the standard value.
Standard value:
No. 1 crossmember
Crossmember
Caution
When pressing in, apply a solution of soap and water to
the sliding part of the bushings, and then press them in
without stopping one after the other.
If there is a pause during the pressing operation, the
frictional resistance will prevent installation.
TSB Revision
Right Member, Left Member and Crossmember
Bushing B 7.5 - 10.5 mm (.30 - .41 in.)
Bushing A 7.2 - 10.2 mm (.28 - .40 in.)
6.5 - 9.5 mm (.26 - .37 in.)
Bushing B