Mitsubishi 3000GT 1991 Service Manual page 632

27-36
Grease
J
REAR AXLE <AWD>
(5) Remove the companion flange and drive pinion once
(6) Apply a thin coat of multipurpose grease to the
11 D554
(7) Install the drive pinion assembly and companion flange
to verify that the drive pinion rotation torque complies
with the standard value.
Standard value
Bearing
classification
11223
N e w / r e u s e d
If there is a deviation from the standard value, check
whether or not there is incorrect tightening torque of
the companion flange tightening self-locking nut, or
incorrect fitting of the oil seal.
18. INSTALLATION OF DRIVE GEAR
(2) Use an Ml0 x 1.25 tap to remove the adhesive adhering
to the threaded holes of the drive gear, and then clean
the threaded holes by applying compressed air.
TSB Revision
again.
Drive the oil seal into the qear carrier front lip by using
the special tool.
Apply multipurpose grease to the oil seal lip.
companion flange contacting surface of the washer
before installing drive pinion assembly.
with mating marks properly aligned, and tighten the
companion flange self-locking
torque by using the special tools.
Bearrng
lubrication
N o n e ( w i t h
rust-prevention oil)
Gear oil
application
nut to the specified
Rotation torque
Nm (in.lbs.)
0.5 - 0.7
0.35 - 0.45