Mitsubishi 3000GT 1991 Service Manual page 868

DISASSEMBLY AND REASSEMBLY
Grease: Silicone grease
Disassembly steps
3.
Clip
4. Wire
l 5. Dust cover
*
6. Bleeder caps
7. Bleeder screws
8. Cylinder assembly
Rod
(4) When the tie rod ends and the installation holes at the
trailing arm do not meet, loosen the tie rod end securing
nut, then adjust the length. The dust cover fastener clip
should be removed for this.
(5) The difference between the lengths of the left and right' Lj
tie rods should be less than 1 mm ( ,039 in.).
NOTE
The threads of the tie rod ends may be used as a guide
for this.
2
SERVICE POINTS OF REASSEMBLY
5. INSTALLATION OF DUST COVER
Apply the specified grease to the place indicated in the
illustration, then install the dust cover to the cylinder
assembly.
Specified grease: Silicone grease
2. INSTALLATION OF TIE ROD END ASSEMBLY
Temporarily attach the tie rod end assembly to the cylinder
assembly at the place of dimension as illustrated.
NOTE
adjust
To
assembly, remove the dust cover clip and rotate the rod.
TSB Revision
the assembly dimensions of the tie rod end