Drive Belt; Power Steering Pump); Engine Oil - Mitsubishi 3000GT Service Manual

Generator
Tension pulley
Idler pulley
I
Tension A
Crankshaft
pulley
pulley
pump pulley
Air conditioning
Crankshaft
compressor pulley
pulley
GENERAL
8. DRIVE BELT (For Generator, Water Pump,

Power Steering Pump)

(Check condition)
Check the tension of the drive belt. Inspect the drive belt
for evidence of cuts and cracks, and replace it if defective.
(1) Measure the deflection with a force of 100 N (22 Ibs.)
applied to belt mid-point
illustration. If the standard value is not obtained, make
adjustment.
(2) On vehicles without air conditioning, set a tension gauge
at a position maked with arrow A in the illustration to
measure the belt tension.
Standard value:
01 FOO07
items
For generator
For P/S pump
Power steering
and A/C
0 0 0 0 2 5 3 2
compressor
For P/S pump
9. ENGINE OIL (Change)
Always use the specified oil. (Refer to P.OO-38)
Caution
Never use nondetergent or straight mineral oil.
(1) After warming up the engine, remove the oil filler cap.
(2) Remove the drain plug and drain the engine oil.
(3) Tighten the drain plug to 40 Nm (29 ftlbs.).
(4) Pour new engine oil through the oil filler.
Caution
1. Cover the generator with shop towel before filling
engine oil to make sure that even if oil is spilt, it
may not drop on the generator.
2. Use an oil mug or a funnel to fill oil.
Engine oil total capacity: [including oil filter and oil
cooler]
(5) Check to ensure that the engine oil level is within the
level range indicated on the oil dip stick.
TSB Revision
between pulleys shown in the
Specification
350-600 (77- 132)
Tension N (Ibs.)
Deflection mm (in.)
<Reference value>
Tension N (Ibs.)
Deflection mm (in.)
<Reference value>
Specification
Deflection mm (in.)
<Reference value>
Tension N (Ibs.)
Deflection mm (in.) 9.5-l 3.5 (.37-.53)
<Reference value>
I