Mitsubishi 3000GT 1991 Service Manual page 334

DISASSEMBLY AND REASSEMBLY
Disassembly steps
2. Waste gate actuator
3. Coupling
l * 6. Cartridge assembly
l O-ring
* 7.
8. Compressor cover
INTAKE AND EXHAUST - Turbocharger
SERVICE POINTS OF DISASSEMBLY
5. REMOVAL OF SNAP RING
Place the compressor cover assembly on the floor with its
end surface down and remove the snap ring with pliers.
Caution
During removal, hold with a finger the snap ring which
can spring out.
6. REMOVAL OF CARTRIDGE ASSEMBLY
Remove the cartridge assembly by tapping the compressor
cover with a soft hammer.
Caution
Some resistance will be experienced in the removal due
to the O-ring on the cartridge assembly.
12 Nm