Mitsubishi 3000GT 1991 Service Manual page 323

INTAKE AND EXHAUST
REMOVAL AND INSTALLATIQN
I Post-installation ODeration
Adjustment of Accelerator Cable
(Refer to GROUP 13 - Engine Control.)
Removal steps
2. Connection of accelerator cable
3. Throttle body assembly
l * 4. Throttle body gasket
5. Connection of brake booster vacuum hose
6. Harness connecters
7. Connection of VIC servo motor
EGR pipe
8.
9. EGR valve
11. EGR temperature sensor
12. Accelerator cable bracket
Throttle body
13. Connection of air intake plenum stay
<Vehicles for
15. Air intake plenum installation nuts
California>
16. Air intake plenum
17. Air intake plenum gasket
SERVICE POINT OF REMOVAL
3. REMOVAL OF THROTTLE BODY ASSEMBLY
Leaving the water hoses and vacuum hoses in their
installed positions, remove from the air intake plenum.
INSPECTION
Check the following points; replace the part if a problem is
found.
AIR INTAKE PLENUM
defective or cracked.
(2) Check load (negative pressure) of drain port. Clean if
required.
SERVICE POINT OF INSTALLATION
4. INSTALLATION OF THROTTLE BODY GASKET
Install with the gasket protrusion positioned as shown.
Caution
If installed in an incorrect direction, idling failure or
other problems may occur.
Revision
8 6 0 N m
13 ft.lbs.
43 ft.lbs.