Open Circuit; Short Circuit; Knock Sensor (Ks) Removal/Installation [Z6] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes

Open circuit

• If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
- BARO sensor terminal C and PCM terminal 2W
- BARO sensor terminal A and PCM terminal 2AX
- BARO sensor terminal B and PCM terminal 2S

Short circuit

• If there is continuity, there is a short circuit. Repair or replace the wiring harness.
- BARO sensor terminal C and body GND
- BARO sensor terminal A and body power supply
- BARO sensor terminal B and body GND
- BARO sensor terminal B and body power supply

KNOCK SENSOR (KS) REMOVAL/INSTALLATION [Z6]

1. Remove the battery cover. (See
2. Disconnect the negative battery cable.
3. Remove the intake manifold. (See
4. Install the SST to the KS.
Downloaded from
BATTERY REMOVAL/INSTALLATION
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
https://carmanualshub.com/
[Z6].)
- automotive repair manuals website
B3E014018920W03
[Z6].)