Suspension Control Arm / Bushing Disassembly And Assembly - Suzuki GRAND VITARA JB416 Service Manual

2B-14 Front Suspension:
Suspension Control Arm / Bushing
Disassembly and Assembly
Disassembly
1) Remove rubber stopper (1).
2) Cut rubber (2) of flange of suspension control arm
front bushing.
3) Using grinder (3), grind off flange (4) of front
bushing.
CAUTION
!
Be careful not to damage suspension control
arm (5) when grinding flange (4) of front
bushing with grinder.
4) Push out bushing by using hydraulic press (2) and
special tools.
Special tool
(A): 09945–55410
(B): 09913–75821
Assembly
!
S5JB0E2206011
Apply grease (included in the repair kit) to
ball joint and inside of ball stud boot when
the ball stud boot is replaced.
1) Front bushing
Press-fit front bushing (1) by using special tools and
press (2).
Special tool
(A): 09945–55410
(B): 09913–75821
!
Be sure to use new bushing.
2) Install rubber stopper (1).
I5JB0A220027-02
Suspension Control Arm / Steering Knuckle
Check
Inspect for cracks, deformation or damage.
If defective, replace.
1
(B)
(A)
I5JB0A220035-01
CAUTION
CAUTION
2
(B)
1
(A)
I5JB0A220036-01
I5JB0A220037-01
S5JB0E2206012
I5JB0A220038-01