St Travel Steering Travel - Ko Propo EX-2 Instruction Manual

STEERING
TRAVEL
Modify the overall amount of steering movement.
ST TRAVEL トラベル
ST TRAVEL：100
L 70％
▶ ST TRAVEL
Modify the overall amount of steering movement.
▶ L（BALANCE）
Modify the left steering angle end point.
▶ R（BALANCE）
Modify the right steering angle end point.

▶ ST TRAVEL Steering Travel

Adjust the overall amount of steering servo movement
when the steering wheel is at full lock.
【Setting Range】
ST TRAVEL : 0 〜 150
（Default : 100）
Since the Balance setting value is a ratio of the
P
Travel setting value, if the latter is modified the actual
movement value and the displayed graphic will also
change.(the Travel value will not change).
Steering will not operate if the Travel value is set to 0.
N
R70%
▶ ST BALANCE L R Steering BalanceL R
Adjust the left/right steering angles independently.
This enables the turning radii to match up during
cornering.
【Setting Range】
ST BALANCE L : 30 〜 100
（Default : 70）
ST BALANCE R : 30 〜 100
（Default ： 70）
The set percentage is a ratio of the value set by the
P
Steering Travel.
Steering balance can be adjusted by using
P
the steering wheel and ET key!
f an ET key that is assigned to steering trim is pressed
while the steering is turned over halfway in either
direction, the balance of the direction of the turn can be
adjusted.
If the trim is set to a large value, a large left/right value
P
discrepancy may result. If adjusting steering balance for
the first time, follow the procedures below.
① Set trim value to 0.
② Adjust sub trim so that the car drives in a straight line
when steering is in neutral position.
③ Use steering travel to match the overall steering
angle range.
④ Use steering balance to match the left/right turning
radii.
⑤ If the car does not drive straight at this point, use trim
to correct.
38