Preparations; Battery Installation; Battery Level Warning; Operation Alarm - Ko Propo EX-1 Instruction Manual

■ Preparations

●Battery Installation
1.
Press the tab on the bottom of the transmitter to open
battery box cover.
Battery Box Cover
2.
Remove the lock to pull out battery
box.
3.
Install four R03/AAA/UM4 alkaline
batteries while noting their polarity,
then replace
battery box.
Battery Box
Use batteries which have adequate remaining capacity. Weak
batteries mean lower transmitting power and may result in
malfunctions.
Do not install Ni-Cd or Ni-MH batteries in the battery box.
(These may cause the battery connectors to corrode.)
●Battery Level Warning
The power source used may be set in Power Management. A
warning will be displayed and an alarm will sound when low
battery voltage is detected. When you see this warning, stop
your model in a safe area and install new transmitter batteries.
[Warning Display on Startup]
[Warning Display During Use]
●Operation Alarm
An alarm will sound after 3 minutes of transmitter idleness.
Operating the steering wheel, ET Keys, BT Button, Direct
Buttons, etc. will disable the alarm.
R03/AAA/UM4
Batteries (4pcs.)
●Battery Pack
A rechargeable battery pack specific to the EX-1 is under
development. An announcement will be made on the KO
Propo website when it is ready for release. Thank you for your
patience.
9
Operation of the transmitter's jog dial, buttons, or levers will
temporarily disable the low-voltage warning sound. The warning
will be displayed again after a certain amount of time has passed.
Voltage value is not display and display "Low".
(Under Development)
Make sure to fully charge the battery pack before installing it.