Table of Contents
Advertisement
Repeater – Installation and Programming Manual
7.2.2 Setting the Date and Time
Attention: The setting of the date and time is available only from access level 3!
In this submenu the installer can set the current time and date for the panel.
To access the TIME/ DATE submenu, enter in the installer's menu - 6. GENERAL SETTING - 6.2) TIME/
DATE. The screen displays:
The editable field is blinking. Use the up and down arrows to set the date and time. Use the left and right
arrows to switch over the editable fields.
IMPORTANT NOTES!
The Repeater panel is equipped with built-in battery for saving the set time and date in case
of main or back-up power supply lost.
Put a jumper on JP7 terminals on the control panel PCB to enable the built-in battery
and saving the set time and date.
7.2.3 Panel General Settings
In this submenu the installer can make some adjustments for the panel performance.
To access the PANEL SETTINGS submenu, enter in the installer's menu - 2. GENERAL SETTING - 2.3)
PANEL SETTINGS. The screen displays:
-
(1) LANGUAGE - Press to set the language. Every
pressing of the button changes the currently used
language for the menus.
(2) - Brightness - Press to increase the brightness
of the screen back light. The maximum value is 20.
(3) + Brightness - Press to decrease the brightness
of the screen back light. The minimum value is 0.
(4) MORE>> - Press to switch to other panel settings.
Confirm all settings with pressing ENTER button.
7.2.4 Company Logo
Enter company name and site description using the arrow buttons as described in APPENDIX A. The
description can be entered on 2 rows with up to 40 symbols (including spaces) each. To enter symbols and
letters use the buttons with up and down arrows. The cursor is moved with the left and right arrow buttons.
After entering the full system name and Information for the site, press "ENTER" button to save it. See also
APPENDIX A.
Increasing
Decreasing
+
6 9
19
Switching between the
editable fields
(3) BUZZER - Press to enable/ disable the
buzzer
signalization.
(4) << BACK - Press to switch back to previous
settings.
Confirm all settings with pressing ENTER button.
Advertisement
Table of Contents
