Time Periods - Teletek electronics CA60Plus Installation Manual

ADDRESS 40
EXIT TIME
DEFAULT : 45 seconds
ADDRESS 41
ENTRY TIME
DEFAULT : 15 seconds
ADDRESS 42
BELL TIME
DEFAULT : 3 minutes
ADDRESS 43
BELL DELAY
DEFAULT : 0 seconds
ADDRESS 44
SET CLOCK
DEFAULT : 00:00 hours
ADDRESS 45
SET DATE
DEFAULT : 01.01
22

4. Time periods

PROGRAMMING EXIT TIME
Exit time is assigned to Entry/Exit type zones. A double-digit figure between 1
and 99 seconds is entered. For an interval of time, less than 10 seconds, the first
digit must be 0.
The indication is hexadecimal and the digits are displayed one by one. To view
the introduced data, the digits can be browsed with the help of the arrows.
PROGRAMMING ENTRY TIME
Entry time is assigned to Entry/Exit type zones. A double-digit figure between 1
and 99 seconds is entered. For a time interval of less than 10 seconds, the first
digit must be 0.
The indication is hexadecimal and the digits are displayed one by one. To view
the introduced data, the digits can be browsed with the help of the arrows.
PROGRAMMING BELL TIME
Duration is set for the bell time of the sirens. A double-digit figure between 0
and 99 minutes is entered. For a time interval of less than 10 seconds, the first
digit must be 0.
The indication is hexadecimal and the digits are displayed one by one. To view
the introduced data, the digits can be browsed with the help of the arrows.
PROGRAMMING BELL DELAY TIME
Delay is set for initiating the bell time of the sirens. A double-digit figure between
0 and 99 seconds is entered. For a time interval of less than 10 seconds, the first
digit must be 0.
The indication is hexadecimal and the digits are displayed one by one. To view
the introduced data, the digits can be browsed with the help of the arrows.
SETTING THE BUILT-IN CLOCK
The hours and minutes are set (HH:MM). The indication is hexadecimal and
the digits are displayed one by one. To view the clock, the digits can be browsed
with the help of the arrows.
SETTING THE DATE
The date and month are set (DD.MM). The indication is hexadecimal and the
digits are displayed one by one. To view the date, the digits can be browsed with
the help of the arrows.
CA60Plus control panel Installation manual