Yamaha WaveRunner GP1300R Service Manual page 476

HULL
HOOD
HANDLEBAR
SERVICE POINTS
Handlebar inspection
1. Check:
• Handlebar
Bends/cracks/damage → Replace.
Handlebar switch inspection
Refer to "IGNITION SYSTEM" and "START-
ING SYSTEM" in Chapter 7.
Handlebar assembly installation
1. Adjust:
• QSTS cable length a
QSTS cable length:
72 ± 0.5 mm (2.83 ± 0.02 in)
NOTE:
• Before adjusting the QSTS cables, set the
control grip to the neutral position.
• Adjust the QSTS cables to the specified
length a and be sure to take up any slack if
necessary.
2. Install:
• Upper handlebar holders 1
NOTE:
• Align the punch marks a on the handlebar
with the top surface of the lower handlebar
holders.
• Install the upper handlebar holders with the
punch marks b facing forward.
CAUTION:
Clearance c should be narrower than
clearance d.
8-6
E