Yamaha WaveRunner GP1300R Service Manual page 184

FUEL
1
a
3
OIL PUMP
a
2
b
Oil pump lever position adjustment
1. Check:
• Oil pump lever position
Incorrect → Adjust.
Checking steps:
• Remove the intake duct.
Refer to "INTAKE DUCT AND INTAKE
SILENCER."
• Squeeze the throttle lever to fully open
the throttle valve lever.
• Check that the gap of the oil pump lever
is 0–0.5 mm (0–0.0197 in) a.
• Install the intake duct.
Refer to "INTAKE DUCT AND INTAKE
SILENCER."
2. Adjust:
• Oil pump lever position
Adjustment steps:
• Remove the intake duct.
Refer to "INTAKE DUCT AND INTAKE
SILENCER."
• Loosen the locknut 1 and adjusting nut
2 of the throttle cable.
• Adjust the throttle cable length to 18.5 ±
1.0 mm (0.728 ± 0.039 in) a.
• Tighten the locknut and adjusting nut.
CAUTION:
Check that the cover 3 is securely
installed.
Locknut and adjusting nut:
11 N • m (1.1 kgf • m, 8.0 ft • lb)
• Check that there is free play between the
throttle cable and throttle valve lever.
• Squeeze the throttle lever to fully open
the throttle valve lever.
• Check that the gap of the oil pump lever
is 0–0.5 mm (0–0.0197 in) b.
• Install the intake duct.
Refer to "INTAKE DUCT AND INTAKE
SILENCER."
4-28
E