Qsts Cable Inspection And Adjustment - Yamaha WaveRunner GP1300R Service Manual

INSP
ADJ
CONTROL SYSTEM

QSTS cable inspection and adjustment

1. Measure:
• Jet thrust nozzle set lengths a and b
Out of specification → Adjust.
Measurement steps:
• Set the control grip to the neutral posi-
tion.
• Set the jet thrust nozzle in the center
position.
• Measure jet thrust nozzle set lengths a
and b.
• If lengths a and b are not even, adjust
the cable joint.
2. Adjust:
• QSTS cable
Adjustment steps:
• Set the control grip to the neutral posi-
tion.
• Loosen the locknut 1.
• Remove the nut 2 and pivot pin 3.
• Set the jet thrust nozzle in the center
position.
• Turn the cable joint 4 in or out to adjust
lengths a and b.
Turn in
Turn out
WARNING
The cable joint must be screwed in a
minimum of 8 mm (0.31 in).
• Connect the cable joint 4 and pivot pin
3, and then tighten the nut 2.
Nut:
3.8 N • m (0.38 kgf • m, 2.7 ft • lb)
• Tighten the locknut 1.
Locknut:
4 N • m (0.4 kgf • m, 2.9 ft • lb)
3-4
Length b is increased.
Length a is increased.
E