Ricoh C226 Service Manual page 274

DIFFERENCES BETWEEN MODELS
No. Item
3. Main Control PCB
SM
Remarks
NOTE:
1) The small upper guide platesare needed when thin or
2
normal paper (80g/m or 20 lb. and thinner paper) is
used. The guide plate is not needed for thicker paper. If
the paper is too thick, it may be caught by the upper
guide plates. (Thick paper can be stacked evenly
without the upper guide plates.)
2) When the small upper guide plates are used, the paper
delivery table's stack capacity reduces to about 750
sheets (depending on paper type). Close the guide
plates to achieve the maximum paper stack capacity.
3) The optional TAPE MAKER works with up to 500
sheets (depending on paper type).
The C224 model's A/D Conversion PCB is not used. The
function is now included in the Main Control PCB, which
is located beneath the scanner unit. Since the Main
Control PCB was moved from the operational side, the
Power Supply PCB was also moved from the
non-operation side of the machine to where the Main
Control PCB was located in the C224 model.
8-3 C226