Ricoh C226 Service Manual page 162

2) SP Mode No. 31 and 37 – SCN/ADF Center Adjust
The printing position moves as shown below.
← Direction
X mm
+X: Moves up X mm
-X: Moves down X mm
NOTE: When adjusting the scanner image position, input "0" first:
Example)
3) SP Mode No. 88 – Auto Class Mode
In the One Touch Class mode, the machine will normally stop when the first
print job is finished if the tape marker is not installed.
If "1" is selected in this mode, the machine will stop for a while (this interval is
the same as when the tape marker is operating). Then the machine will
continue with the next print (or master making) job.
SM
SERVICE PROGRAM TABLE (I/O CHECK MODE)
Original Position
Printing Position
Printing Position
X = 0.9 mm → "0" "9" then press the # key.
4-19 C226