Ricoh C226 Service Manual page 189

IMAGE SHIFTING SECTION
[D]
5. Disconnect the connector [D] of the encoder.
6. Insert the gauge [A] into the hole of the gear [E].
7. Turn on the machine and monitor of the Image shift indicators on the
operation panel (LED-2 is lit). Gradually turn the shaft of the encoder [B]
in the "0" position direction and stop as soon as the "0" position LED is lit.
8. In the above condition, set the encoder and tighten the allen screw [F] to
mount the shaft of the encoder with the gear [E]. Then remove the gauge
[A] and connect the connector [C] of the image shift motor.
9. After adjustment, make several prints to confirm the image position.
C226
[C]
[F]
[B]
5-16
[E]
[A]
SM