Installation - Ricoh C226 Service Manual

3.2 INSTALLATION

[A]
Main Body:
1. Turn off the main switch and unplug the power cord.
2. Remove the rear cover (6 screws).
3. Replace the screw [A], to secure the AC drive PCB with M4 x 25 screws
(accessory).
4. Reinstall the rear cover.
5. Install the auxiliary bracket [B] on the main body with the hexagon nut [D]
(accessory) as shown.
NOTE: Install the lock washer [C] (accessory) with the nut.
Tape Marker:
6. Install the tape marker on the auxiliary bracket with two M4 x 8 screws [E]
(accessory).
NOTE: Install the lock washer [F] (accessory) with one of the two screws.
7. Connect the connector to the main body.
SM
TAPE MARKER INSTALLATION
[B]
3-15
[C]
[D]
[F] [E]
C226