Ricoh C226 Service Manual page 133

INSTALLATION PROCEDURE
11. Test Printing
a. Place an original face down and
close the platen cover.
b. Press the master making key and
press the Start key.
NOTE: With a new machine,
"MASTER EJECT JAM" will
be displayed because there
is no master yet on the
drum. Disconnect the drum
and slide the drum unit out
of the machine about four
(4) inches to dis-engage the
drum safety switch.
Re-insert the drum and
press the start key.
c. After one sheet of paper is
delivered, make prints at the lowest
print speed (1) until the print image
density stabilizes. Use a test chart
to check for changes in the image
density.
d. Check the copy quality after the
image is stabilized.
12. This procedure is for the NRG
version model only.
Attach the brand decal [A] as shown
below.
C226
[A]
14 mm
42 mm
3-10 SM