Master Eject Clamper Cam Adjustment - Ricoh C226 Service Manual

9.6 MASTER EJECT CLAMPER CAM ADJUSTMENT

ON= 29 ± 0.5 mm
Purpose: To position the master eject clamper cam so that the master clamper
opens correctly during the master eject process and closes correctly
for all other processes.
1. Remove the drum unit from the machine and open the master eject unit.
2. Remove the rear cover of the machine.
3. Access "I/O Check Mode".
•
Use Output Check mode (SP131) No.16.
4. Press the Print Start key to energize the master eject clamper solenoid
[A].
5. Ensure that the distance between the bushing and the edge of the
opening cam [B] is 29 ± 0.5 mm when the master eject clamper solenoid
is energized
6. If not, loosen the mounting screws [C] and adjust the position of the
master eject clamper solenoid.

CAUTION
Do not turn on the solenoid any longer than 10 seconds.
7. After adjustment, retighten the mounting screws.
C226
[C]
[B]
OFF= less than 25 mm
5-52
DRUM SECTION
[A]
[B]
SM