Menu Overview; Touchscreen Display; Print / Setup; Navigation - 3D Systems Cube User Manual

MENU OVERVIEW

Touchscreen Display

After powering on the printer, touch the display to start .
CAUTION: When navigating the touchscreen display, use only
light finger pressure to make selections. Using anything sharp will
damage the touchscreen display and will void the manufacturer's
warranty .
NOTE: You may press and release the button next to the
touchscreen display to return to the PRINT / SETUP menu .

Print / Setup

PRINT
PRINT allows the user to print a creation stored either on a USB mass storage
device or directly from Cubify software . You can invent your own creation using
Cubify Invent software available at www .Cubify .com .
SETUP
SETUP allows the user to configure the printer, connect to a wireless or ad hoc
network, connect to a Bluetooth device, install cartridges, and view the printer status .

Navigation

Navigation between screens is performed by pressing the right or left arrows .

Materials

CARTRIDGE STATUS
CARTRIDGE STATUS allows you to view the type and color of the material that is
installed . It also displays the estimated amount of material left in the cartridge .
CHANGE CARTRIDGE
Selecting CHANGE CARTRIDGE
replace installed cartridges .

Print Plate Calibration

AUTO LEVEL
AUTO LEVEL is an automated procedure that measures the level of the print pad . If
the print pad is found to be out of specification, the touchscreen will prompt the user
to use the adjustment screws to level the print pad .
AUTO GAP
Following AUTO LEVEL, AUTO GAP
distance between the print pad and the print jets. If the gap is out of specification, the
user can perform the Manual Gap procedure .
3D Systems, Inc.
allows you to install cartridges in empty bays or
is an automated procedure that measures the
23