3D Systems Cube User Manual page 33

NOTE: If the print file requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s) .
Select CHANGE CARTRIDGE
A Material Cartridge
NOTE: If the print file requires ABS material and PLA material is
installed, the printer will prompt you to change the cartridge(s) .
Select CHANGE CARTRIDGE
A Material Cartridge
NOTE: If there is not enough material to complete the print but you
want to use up the remaining material, select the
continue printing .
NOTE: If the file was built with color(s) that are not installed, the
printer will assign a color from one of the installed cartridges that
match the material type . Select the
4 . Apply two thin layers of Cube Glue to the center of the print pad . Select the
checkmark to continue .
NOTE: Ensure that the area where glue is applied is larger than the
dimensions of the base of your creation .
NOTE: For best results, allow the glue to dry before printing .
3D Systems, Inc.
and refer to the section titled
for instructions about replacing a cartridge .
and refer to the section titled
for instructions about replacing a cartridge .
checkmark
Replacing
Replacing
checkmark to
to continue .
29