Printer Calibration - 3D Systems Cube User Manual

PRINTER CALIBRATION

Printer Calibration is originally performed by the manufacturer . When Level Gap, Auto Gap and Manual Gap have been successful but
the bottom layer of your print appears stringy and not tightly fused together, your printer should be calibrated .
NOTE: Auto Level should always be performed before the Auto Gap procedure .
1 . Navigate to the Printer Calibration screen and select CALIBRATE .
2 . Select Auto Cal .
NOTE: The printer will maneuver the print pad to center it and then
position it under the print jet nozzles .
3 . Lower the value on your display by 1 .00 using the down arrow .
NOTE: The value displayed may be different from the illustration .
Referring to this illustration, your target value would be close to
-4 .76 . If the value displayed is 6 .23, your target value would be close
to 5.23. The final adjustment value should be close to the target
value but does not need to be exact .
4 . Insert the gap gauge between the print pad (A) and the left print jet nozzle (B) .
NOTE: The left print jet is print jet 1 .
3D Systems, Inc.
B
95
A