3D Systems Cube User Manual page 114

NOTE: The firmware will begin to install. The blue bar is a progress
indicator .
NOTE: The installation could take a few minutes .
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS .
4 . When prompted, press and release the
turns on .
NOTE: It may take a minute for the display to turn on .
5 . Perform the Auto Level and Auto Gap procedures .
NOTE: For more information, refer to the section titled
Calibration .
3D Systems, Inc.
power button and wait until the display
Print Pad
110