3D Systems Cube User Manual page 103

4 . When prompted, tighten the lock screw enough to ensure the adjustment knob
does not easily turn . Select the
Caution: Do not over-tighten the lock screw . This can damage the
adjustment knob and void the manufacturer's warranty.
5 . Reinstall the print pad and select the
procedure again .
NOTE: Select SKIP
recommended that Auto Level procedure is performed again .
6 . Once Auto Level is successful, the printer will being checking the Z-gap .
NOTE: The printer will perform an automated gap measurement .
This may take a few minutes .
7 . Select the checkmark
NOTE: If Auto Gap is not successful, it is recommended that you
perform Auto Level and Auto Gap again . Select
continue .
NOTE: If Auto Gap is not successful the second time, select
MAINTENANCE . For more information, refer to the section titled
Print Pad Maintenance . Once the Plate Maintenance procedure has
been performed, perform Auto Level and Auto Gap .
NOTE: If Auto Gap is still not successful, select
ADJUSTMENT . Refer to the section titled Manual Gap Adjustment for
more information . Once the Manual Gap Adjustment procedure has
been performed, note the final reading for future reference.
3D Systems, Inc.
checkmark to continue .
checkmark to perform the Auto Level
to bypass the Auto Level procedure . It is
to continue .
AUTO LEVEL to
PLATE
MANUAL GAP
99